Industrial-data-systems IDS Scale Basic Uživatelský manuál Strana 38
- Strana / 53
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
Scale Basic 4.2E Reference
Netmode 103
Purpose: true if display is in Net mode.
Overload 115
Purpose: true if scale status = Overload
Positive 101
Purpose: true if previous calculation result was Positive.
Remarks: Also set by Get id and Make id to signal that the instruction was successful.
Printable 108
Purpose: true if the weight registers (Gross/Net) contain printable (handbook 44) weight.
Qstatus 110
Purpose: true if communications port 2 receives an ‘I’ status from a previous status request or if
communications port 2 receives a ‘V’ (valid weight) from a previously sent RQ message.
Remarks: Qstatus is used when multiple indicators are connected together in a network. The
networks are normally setup in a Master/Slave configuration.
The Master unit sends out status inquires [S] to the slave units. The slave units send back an [I]
if they are idle (Qstatus is turned ON) or a [B] if they are busy (Qstatus is turned OFF).
The Master units sends out an RT request to automatically read a slave units data registers
(including Gross and Net registers). The Qstatus flag is set if the slave units weight registers
contain printable (handbook44) weight.
Setpoint 1…15 1…15
Purpose: true if SetpointX is active.
Timer 1…5 41…45
Purpose: true if TimerX is active.
Tx2ready 114
Purpose: true if Com port 2 transmit is ready (not busy sending a previous message).
Zero 100
Purpose: true if previous calculation result was Zero.
Remarks: Also set by Get id and Make id to signal that the instruction was un-successful.
- Scale Basic 1
- Table of Contents 2
- Introduction 3
- EZ Link 4
- EZ Link Configuration 5
- EZ Link Test 6
- Event Driven Programming 10
- Scale Basic Tutorial 12
- Arithmetic and Registers 13
- Setpoint Monitors 16
- Reference 21
- Dec [r] 205 [r] 22
- Display [r] 218 [r] 22
- Get data [r] 231 [r] 24
- Get key 230 25
- Get id [r] 234 [r] 25
- Inc [r] 204 [r] 27
- Index id [r] 217 [r] 27
- Make id [r] 235 [r] 29
- Nop 254 30
- Sign [r] 207 [r] 32
- Valid wt 219 34
- Write id 228 35
- Timer Events 44
- TTL Input Events 45
- Registers 49
- Memory Registers 49
- Fixed Registers 49
- Scale Registers 49
- ID Registers 50
- Other Registers 50
- Error Codes 52
- Appendix A: Design Template 53
Související produkty a manuály pro Software Industrial-data-systems IDS Scale Basic
(6 stránky)Krohne OPTIBAR P 3050 C RU manuels
Manuels d'utilisation et guides de l'utilisateur pour Équipement Krohne OPTIBAR P 3050 C RU.
Nous fournissons des manuels en pdf 1 Krohne OPTIBAR P 3050 C RU à télécharger gratuitement par type de document : Manuel de l'utilisateur
Komentáře k této Příručce